Automatic planning tool
LED Wall Calculator
Enter specifications for one screen and its cabinets. The layout, controller match, data-cable estimate and maximum power load update automatically from your inputs.
Auto-updating plan
Project inputs
Step 1 · project and screen
Screen dimensions
Enter dimensions for one screen. Cabinet specifications, routing and power assumptions are configured in the next steps.
Step 2 · exact cabinet specifications
Main Stage Screen
Choose an optional supplied-sheet starting point or enter values from the exact cabinet datasheet.
Preset fields are optional; custom datasheet values work the same way.
Presets prefill only pitch options and cabinet dimensions stated in the supplied sheet. Native pixel matrices produce exact screen resolution; without both values, resolution is estimated. Missing matrix, power, weight and cabinet dimensions are never guessed.
Curved wall geometry
Optional geometry estimate for this screen; not structural or rigging approval.
Step 3 · output routing and power
Three-phase current and circuit estimates remain blank until the line-to-line voltage, 3-pole breaker and balanced-load assumption above are confirmed. Phase allocation, imbalance and cabinet power-distribution topology are not modeled. Estimates only—not conductor sizing or code approval.
The controller/data-rate planning basis is 10-bit at 60 fps. A source-backed 10-bit per-port limit is preferred where available; confirm the exact controller, receiver-card and operating mode before equipment selection.
Generated as you type
New LED Wall Plan
Single display screen
Enter dimensions for one screen and its exact cabinet data. The map, controller, cable and power estimates update automatically; no Generate button is needed.
Active screen area
—
Fitted cabinet area
Cabinets
—
Requires valid wall and cabinet dimensions
Screen pixel load
—
Estimated or exact video canvas size
Pitch starting range
—
Rule-of-thumb guidance from viewing distance
Screen · Main Stage Screen
Cabinet layout
—
Enter screen and cabinet dimensions
Screen resolution
—
Estimated from entered pitch and fitted size
Screen pixel load
—
This screen’s video canvas
Fitted physical size
—
Enter wall dimensions
Automatic NovaStar controller / processor recommendation
Enter screen dimensions, cabinet pixel data and exact controller-relevant values to generate an automatic controller/processor candidate.
Automatic data-cable estimate
Cable counts remain blank until this screen has a source-backed controller fit. Connector type, cable lengths, receiver-card limits and site route must be confirmed.
Counts are derived from published per-output pixel limits and the entered or estimated cabinet matrix. Confirm the final route and physical lengths against the exact system.
Automatic power requirements estimate
Enter this screen’s exact cabinet maximum watts to calculate the load. Missing power values are not guessed.
Current uses entered maximum watts, voltage, phase and power factor. Three-phase values require the confirmed balanced-load basis above; phase allocation and cabinet power-distribution topology are not modeled. Circuit count is indicative only; verify supply, breaker coordination, manufacturer distribution and local code. This does not size conductors or feeders.
All maps, controller matches, cable counts and power values are planning estimates based on entered data. Confirm the exact cabinet, controller, receiving cards, site route and electrical requirements before procurement or installation.